M SERIES STAR

In this section we show you how we applied the stencil to the rear door on our half track.

Getting the tools right is always a good start and don't forget to clean the surface before you apply.

Decide the right position and, secure in place lightly with masking tape while you check. Measure and position exactly where its needed., some people do use a spirit level to check the position.

Once happy with position create a hinge using masking tape along the top of the stencil.

It maybe necessary to make adjustments to the stencil to get it to fit your vehicle. Here we have had to cut it to allow for the grab handle. Lift the stencil on the hinge and remove the backing paper carefully.

Once removed carefully smooth down on to the body/surface of the vehicle.

Use a squeegee (or credit card, or smooth surface) to remove any air pockets. Carefully peel back the application tape from the front of the stencil.
Resmooth if necassary, again using smooth surface. We chose to use a roller rather than spray paint but your choice is yours. So finally prep done lets start painting, it may take more than one coat so take your time.
Completely cover the stencil, it might take a few coats. Once dry it's try, but not so dry the stencil is stuck your ready to remove. Gently peel back the stencil from the body.

The Finished Result!